Ultrak CCU-100HD Bedienungsanleitung PDF herunterladen (Seite 64)

3-14

3.2.7 AIF-100/CO Contact Output Control Interface

The CCU sends all contact output control data for AIF-100/CO auxiliary

control devices (address 2-250) out the RS-485 output channels 4 and 6.

The AIF-100/CO units are addressable like the FastScan/SmartScan

assemblies. Address 1 cannot be used for AIF-100/CO units. Address 1

is reserved for the optional MX-4248 I/O Board for the HD video switcher.

Manual control of the contact outputs is performed by an operator at a JPD-

100 Joystick Controller. The address of the AIF-100/CO is called up on the

JPD-100 as the primary control camera. Refer to the JPD-100 Operator’s

Manual.

Automatic operation of the contact outputs occurs if auxiliary control

commands are stored in a MultiCall and the MultiCall is started. Refer to

programming MultiCalls in Section 4 of this manual.

3.2.8 Host Computer Interface

The CCU has an RS232 simplex input port (COM1) for a host computer

interface. The host computer can send commands to the CCU to perform

the following functions:

• Video Switcher Call

• Send A SmartScan Unit to a PreShot

• Activate an Alarm

When the CCU receives an activate alarm command from the host

computer, the CCU activates the MultiCall assigned to the alarm point.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 153 154

Keine Kommentare

Ultrak CCU-100HD Bedienungsanleitung Seite 64