Ultrak CCU-100HD Bedienungsanleitung PDF herunterladen (Seite 77)

PROGRAMMING MULTICALLS

4-9

4.3.3.1 P - PreShot

To program the MultiCall to perform a PreShot, perform the following

steps.

NOTE

If the cursor does not automatically move to

the next field after entering data in a field,

press the gray right arrow key to move to the

next field.

1. Enter P in the FUN field.

2. Enter the desired PreShot Number (00-99) in the NUM field.

3. Enter the Camera Number (1-128) where the PreShot is stored in

the CAM field.

4. Enter a transit time (0.0-9.9 seconds) in the MISC field.

The transit time is the amount of time you want the camera to take

to move from its present location to the PreShot position. The

CCU-100 sends the transit time out to the SmartScan unit.

5. Enter a dwell time (00-99 seconds) in the DWELL field.

Dwell time is the amount of time you want the CCU to wait before it

performs the next step in the MultiCall. A “00” dwell time tells the

CCU to perform the functions at the same time. A “15” second

dwell time means that the CCU will wait 15 seconds before

performing the next step in the MultiCall. Note: The transit time

for a PreShot and the dwell time start at the same time.

6. Enter another function or press Enter to end programming. If you

pressed Enter, Press S to save programming or press Esc to end

programming without saving.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 153 154

Keine Kommentare

Ultrak CCU-100HD Bedienungsanleitung Seite 77