Ultrak CCU-100HD Bedienungsanleitung PDF herunterladen (Seite 96)

CAMERA AND MONITOR SETUP

4-28

The default factory settings are as follows:

1) Default camera titles (CAM xxx) and date and time displays are enabled

for all monitors. Note: If the Diamond series SmartScan units are

installed, two camera IDs may be displayed. The SmartScan generates

a camera ID from its address. The SmartScan display can be disabled.

Refer to your specific SmartScan operating and programming manual.

2) Video alarms are disabled.

a) Integration Time for high and low video = 5 seconds.

b) All types of video alarms are assigned to MultiCall 000.

c) The video alarm display monitor is monitor 1.

To change the default settings for the camera titles, monitors, and video

alarms, perform the following steps.

1. Press Shift F10.

2. Press C for Camera/Monitor Setup

3. Press 1 to select the camera number. Type the camera number (1-

128) and press Enter.

4. Press 2 to program a title for the camera number displayed in menu item

1. The default title for the camera (CAM XXX) is displayed. Type the

desired title (up to 18 characters) and press Enter.

5. Repeat steps 3 and 4 until all camera titles are programmed.

6. Press 3 to program the video alarms. The video alarm number is

mapped to the video input number. Video alarm number 3 is mapped to

video input 3. Note: The video alarm should be disabled on all video

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 153 154

Keine Kommentare

Ultrak CCU-100HD Bedienungsanleitung Seite 96